Truck bedliners and trailer coatings
Spray-on polyurea for truck beds, stock trailers, flatbeds and dump bodies. It bonds to the metal or wood, so nothing shifts, rattles or traps water underneath.

What it does
- Grip you choose
- Texture is set at the gun. Coarse for a stock trailer floor that has to hold hooves, finer for a bed you slide tools across.
- No gap underneath
- A sprayed liner is bonded to the surface. There is no space below it for water and grit to sit and start rust.
- Wood and steel alike
- Trailer decks, ramps and gates get the same skin as the steel around them, edges and bolt heads included.
Where it goes
- Pickup beds
- Stock and horse trailers
- Flatbeds and goosenecks
- Dump bodies
- Service bodies
- Ramps and tailgates
Not on the list? Ask. The rig sprays a lot more than fits on a page.
Questions we get
Do you have to remove hardware first?
Anything that should stay bare gets masked or pulled first: tie-downs, lights, latches. Tell us what you want coated and what you do not when you ask for a quote.
Can an older, rusty bed be sprayed?
Usually, once loose rust and any old liner are off and the steel is cleaned and roughed up. The coating is only as good as the surface it bonds to, so prep is most of the job.



